Netgear EAX11 Setup
Doing Netgear EAX11 extender setup has proved to be a daunting task for many people out there. In case, you are also going bonkers because of your inability to do the same, then you have come to the right page. Here, we have talked about how you can setup EAX11 range extender along with other related topics. With that said, keep reading.
How to Do EAX11 Setup via WPS Method?
The easiest way through which configuring the EAX11 range extender is possible is using the WPS method. WPS is short for WiFi Protected Setup.
In order to use this method, it is important that your home router has a WPS button located on it. Considering this, walk through the instructions mentioned in this section and learn how to install your networking device using this method.
By the way, no matter which setup method you use, having access to Netgear_ext is very important. Thus, make sure that you have knowledge of how to access it.
- Locate a working wall socket near the router.
- Once located, plug the extender into it.
- Hit the power button.
- In the blink of an eye, the LED on EAX11 will blink.
- Find the WPS button on the extender.
- When found, press it.
- You need to repeat the same step but with the router.
- Both devices will get connected in some time.
- After that, change the location of your Netgear EAX11 device.
In no time, you will be able to wrap up the Netgear EAX11 setup process. In case, you found this method a little difficult to execute, then you can use any manual method which requires the user of the mywifiext.local web address. For that, you need to make use of the manual as you will find the steps to execute all the setup methods there.
Want to Reset Netgear EAX11 Extender?
The needful can be done if you walk through these step-by-step instructions:
- Ensure that your device is properly plugged into the wall socket.
- Once assured, locate the Reset button on the Netgear EAX11 range extender.
- Press the button as soon as you find it.
- The location of the reset button depends on the model that you are using.
- Hold on for some time.
- Your networking device will automatically reboot.
Although you will face no issues while using the hard reset method to restore your extender to its default factory mode, on the off chance, you do, use the manual method to do the same. For that, you need to access mywifiext.net and too if you are using Windows.
In case you are using a MAC device, then accessing mywifiext.local will be feasible. For more information regarding the same, it is recommended that you refer to the manual of your device. Trust us; you will not regret doing so.